Partial List for my 69 Barracuda WIP 3/26/16 through today When you do a complete Nut and Bolt RestoMod it's expensive. So I made my own.Ĭut down the stock column for all the test fitting.Ĭutting my new firewall plate with my little benchtop router table. The EPAS kit came with a Plate for the firewall but I think they have "Early A" for all the A-Body Barracudas and not correct for 67-69 Barracudas. Ididit says they will disassemble, cut the column and inner steering shaft down to my measurements for $100.00 + shipping and I can maintain the warranty. Now to shorten and modify the Ididit Tilt Column to fit. Collapsible Steering Shaft with Electric Power Assisted Steering. Worked great.Ī 3/4" Double "D" and 1" Double "D", a 3/4" 36 spline to 3/4" DD U-Joint, a 3/4" DD to 1" DD U-Joint, a 1" Bearing at the firewall. Used the original firewall steering column plate as a template and made the new with 3mm thick plate aluminum.Ĭut it out on my bench router table with a trim bit from Harbor Freight. Had to make a plate to go on the firewall and relocate the opening to where the steering shaft will clear everything. Will be mated to an Ididit Tilt Steering Column, Momo Steering wheel and Paddle Shifters. That however would change.ĮPAS Electric Power Assisted Steering for the 69 Barracuda Neon SRT4 Seats sitting in there just to get a look.Īt this point, Manual Reverse Valve Body 727 + GV OD was still the plan. Yes, it is very close to the passenger inner fender. Going to have to drill and cut holes for the Classic auto Air but am thinking of ways to hide as much of the plumbing as possible. Having never done any of this before, I'm taking my time and thinking about what next. Lots to test fit and mock up and then take it back out before final paint. ![]() Several firsts for us but the QA1 K-Member bolted right up with a little bit of coaxing. Rolled the Hemi across the patio and down the driveway and under the waiting 69 Fastback for the first test fitting. ![]() Lifts plenty high with the rear on ramp/blocks.Ħ.1 and 727 are on a US Car Tool K-Member cart.ĭidn't have a transmission mount and none at the local parts store. Testing out the US Car Tool car lifting tool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |